Order Now: $63.99
Hundreds of abrasive “balls” mounted on a flexible shaft – the fastest, easiest way we’ve come across to clean and polish older barrels or put a mirror polish in new ones.
For used barrels, the Medium-Coarse hone, followed by the Fine, removes rough and tight spots and brings the bore to a bright finish that you can see and feel . . . just run a patch through it before and after; the difference is amazing! We found too, that we could feel tight spots during honing and spend extra time on them until they were evened out.
On new barrels, the Fine hone by itself will bring the factory finish up to a beautiful, mirror-bright finish that’s a real customer pleaser.
Easy to use: chuck in a variable speed electric drill; wet the hone with Flex Hone oil; start the drill and insert the hone into the barrel from the breech end (if possible). As it cuts, a slurry of abrasive and oil develops to help speed the cutting action.
Flex Hone available (shown below) in sets and individual hones for 10, 12, 16 and 20 gauge barrels as well as .410 bore. Also, special-sized hones for 10, 12, 16, 20 gauge chambers and .410 bore.
Instructions walk you through the steps for a perfect job. (You MUST use Flex Hone oil – all other oils will destroy the abrasive “balls” and void our guarantee!) 750 RPM MAX. Avoid excess pressure.
SPECS: Flex Hone for Barrels; 10, 12, 16, 20 ga., .410 bore. 33″ (83.8cm) long in Med.-Coarse grit (red tip) or Fine grit (light blue tip).
Flex Hone for Chambers; 10, 12, 16, 20 ga., .410 bore 12″ (6.5cm) long, fine grit (light blue only).
Set includes Med.-Coarse & Fine barrel hones, Chamber hone & 1 qt. Flex Hone oil, for 1 ga. (more . . .)